Apical stress distribution under vertical compaction of gutta-percha and occlusal loads in canals with varying apical sizes: a 3-Dimensional Finite Element Analysis

Abstract

Aim

To investigate and compare the effects of two apical canal instrumentation protocols on apical stress distributions at the root apex under vertical compaction of gutta-percha and occlusal loads using finite element analysis.

Methodology

Three finite element analysis models of a mandibular first premolar were reconstructed: an original canal model, a size 35, 0.04 taper apical enlargement model and a Lightspeed size 60 apical enlargement model. A 15 N compaction force was applied vertically to the gutta-percha 5 mm from the apex. A 175 N occlusal load in two directions (vertical and 45º to the longitudinal axis of the tooth) was simulated. Stresses in the apical 2 mm were calculated and compared among three models.

Results

Under vertical compaction, stresses in the apical canal instrumented by Lightspeed size 60 (maximal 3.3 MPa) were higher than that of the size 35, 0.04 taper model (maximal 1.3 MPa). In the case of the two occlusal forces, the Lightspeed size 60 apical enlargement was associated with the greatest stress distribution in the apical region. The greatest stress and the most obvious stress difference between the models appeared at the tip of the root when occlusal and vertical compaction loads were applied.

Conclusions

Apical enlargement caused stress distribution changes in the apical region. The larger apical size led to higher stress concentration at the root apex.

This article is protected by copyright. All rights reserved.

http://ift.tt/2uChjMC